Happymodel M8 HDZero Lux 80mm 2S Brushless Micro Whoop – Freestyle FPV Racing Drone BNF w/ ELRS 2.4GHz & 15A AIO HD System

Happymodel M8 HDZero Lux 80mm 2S Brushless Micro Whoop – Freestyle FPV Racing Drone BNF w/ ELRS 2.4GHz & 15A AIO HD SystemThe Happymodel M8 HDZero Lux 80mm 2S FPV Micro Whoop is a compact powerhouse designed for backyard freestyle and HD FPV adventures. With its advanced HDZero AIO15 5 in 1 flight controller, high speed RS1102 13500KV motors, and integrated ExpressLRS 2. 4GHz receiver, the M8 delivers a stable, responsive, and high definition flying experience all in a lightweight 33. 5g frame. Key Features: Integrated HDZero AIO15 flight controller with built in 15A ESC

The Happymodel M8 HDZero Lux 80mm 2S FPV Micro Whoop is a compact powerhouse designed for backyard freestyle and HD FPV adventures. With its advanced HDZero AIO15 5-in-1 flight controller, high-speed RS1102 13500KV motors, and integrated ExpressLRS 2.4GHz receiver, the M8 delivers a stable, responsive, and high-definition flying experience — all in a lightweight 33.5g frame.

Key Features:

• ✅ Integrated HDZero AIO15 flight controller with built-in 15A ESC and HD VTX
• ✅ Powerful RS1102 13500KV brushless motors paired with 45mm tri-blade props
• ✅ Crisp and vibrant HDZero Lux Camera with WDR for both 4:3 and 16:9 formats
• ✅ ExpressLRS 2.4GHz built-in receiver for ultra-low latency and long-range control
• ✅ Compatible with most 80mm whoop frames – perfect for freestyle or tight-space flights
• ✅ Runs on 2S LiPo (recommended 550mAh – sold separately)

⚙️ Technical Specifications:

• Wheelbase: 80mm
• Weight: 33.5g (excluding battery)
• Propellers:
  Weight: 0.33g
  Material: Poly Carbonate
  Pitch: 0.9
  Props Dia: 45mm
  Hub Thickness: 5mm
  Shaft: 1.5mm
• Motors:
  Mode: RS1102 KV13500
  Configu-ration: 9N12P
  Stator Diamter: 11mm
  Stator Length: 2mm
  Shaft Diameter: Φ1.5mm
  Motor Dimension(Dia.*Len): Φ13.5mm*14mm
  Weight(g): 2.8g
  No.of Cells(Lipo): 1-2S
• Flight Controller: 
  MCU: STM32G473 (170MHz, 512K Flash)
  Gyro: ICM42688
  On board voltage and amperage meters
  Built-in 15A(each) Blue Jay 4-in-1 ESC
  Built-in 5.8G HDZero VTX
  RF output: 25mw/200mW
  Supported channels: R1-R8, F2/F4, L1-L8
  UFL connector (ultra-lite linear antenna included)
  Built-in Serial ExpressLRS 2.4GHz receiver
  Built-in 5V 3A BEC
  Flight controller firmware target: HDZERO_AIO15
  Power supply: 2S battery (6.4v~8.7v)
  Fully compatible with the popular whoop frames
  Board size: 31.3×31.3mm with a 25.5×25.5 mounting hole size
  Weight: 7.2g (with motor plugs)
  
• Onboard 4in1 ESC: 
  PowerSupply: 2S LiPo/LiPo HV
  Current: 15A continuous,18A peak (3 seconds)
  Support BLHeli_S Bluejay firmware
  Factory firmware: Bluejay ESC V0.19.2Firmware target: Z-H-30 48KHz
  Default protocol: DSHOT300
  
• Camera: 
  HDZero Lux Camera
  Sensor size: 1/2 inch
  Resolution: 720p60 4:3 and 16:9
  FOV: D:155° H:126° V:94°(4:3)
  FOV: D:145° H:126° V:70°(16:9)
  WDR
  
• Receiver: 
  Packet Rate option: 50/100/150/250/333/500/D250/D500/F500/F1000Hz
  RF Frequency: 2.4GHz
  Antenna: Pre-soldered enameled copper wire 31mm length
  Telemetry output Power: <12dBm
  
• Onboard 4in1 ESC:
  PowerSupply: 2S LiPo/LiPo HV
  Current: 15A continuous,18A peak (3 seconds)
  Support BLHeli_S Bluejay firmware
  Factory firmware: Bluejay ESC V0.19.2Firmware target: Z-H-30 48KHz
  Default protocol: DSHOT300

📦 What’s Included:

• 1x Happymodel M8 Frame
• 1x HDZero AIO15 5-in-1 Flight Controller
• 4x RS1102 KV13500 Motors
• 8x HQProp 45mm Tri-Blade Props (4 CW + 4 CCW)
• 1x HDZero Lux Camera
• 1x Lightweight Canopy
• 1x Screwdriver